A woven bag equipment manufacturer tells you: Maintenance tips for integrated cutting and sewing machines

The high efficiency of the slitting machine is inseparable from regular maintenance. Maintenance not only reduces wear and tear on parts but also effectively eliminates potential hazards, greatly contributing to safe operation. Typically, professional technicians possess specialized maintenance techniques for slitting machines, including:

I. Cleaning of the integrated cutting and sewing machine

1. Cleaning the feed dog: Remove the screws between the needle plate and the feed dog, remove lint and dust, and add a small amount of special oil.

2. Cleaning the shuttle bed: The shuttle bed is the core of the sewing machine and also the part that is prone to failure. Therefore, it is necessary to clean the dirt and add a small amount of special oil regularly.

3. Cleaning other parts: The surface and all parts inside the panel of the cutting and sewing machine should be cleaned frequently.

II. Lubrication of the Cutting and Sewing Machine

Specialized machine oil must be used. The equipment should be fully oiled after one or several days of continuous use. If oiling is needed between uses, the machine should be run idle for a short time to allow the oil to fully penetrate and remove excess oil. Then, wipe the machine head and work surface clean with a soft cloth to avoid soiling the fabric. Next, thread the sewing machine and sew the scraps of fabric, using the movement of the sewing thread to clean and remove excess oil until there are no oil stains on the scraps before proceeding with the main sewing.

The manufacturer of the woven bag cutting, printing, and collecting machine tells you: The lubrication points are:

1. The various oil holes on the machine head lubricate the upper shaft and the components connected to the upper shaft.

2. Components inside the panel and the moving parts connecting them. Lubricate the presser foot and needle bar, as well as the parts connected to them.

3. Clean the moving parts of the lower part of the machine plate and add a small amount of oil. The amount of oil in each oil filling hole and oil filling part does not need to be too much, just one or two drops.

Secondly, the following points should be noted when maintaining a slitting and cutting machine:

1. After finishing the work, insert the needle into the needle plate, lift the presser foot, and cover the machine head with the machine cover to prevent dust and debris from entering.

2. When starting work, first check the main components, such as how heavy or light it is when stepped on, whether there are any unusual noises, and whether the needle is normal. If any abnormalities are found, they should be repaired in time.

3. After the machine has been used for a considerable period of time, a major overhaul should be carried out. If any parts are found to be severely worn, they should be replaced with new ones.

The key to maintaining a slitting machine is practicality. We can regularly maintain important and frequently worn parts, which saves time and effort and extends the life of the equipment, achieving two goals at once.